What did you personally accomplish this week on the project?
I spent probably 15 hours on design report so evidently some of my project work is a little lighter this week. However, even though we got the pico later than expected I was able to begin some research and code for that. I drafted out some code for PWM and for duty cycle modulation. I made 2 versions of this, one for SW timed and one for HW timed. Because the pico wasn’t picked up until after I was already on break, I was unable to test yet but hopefully not a difficult process.
Is your progress on schedule or behind? If you are behind, what actions will be taken to catch up to the project schedule?
I am nicely on schedule. Much of our work is now dependent on getting the pico code to work on board. Hopefully this isn’t a terrible process because once its done, then we can shift over to LCD and receiver decoding subsystem.
What deliverables do you hope to complete in the next week?
Next week my main focus is putting and debugging the pico code on the pico. After that, me DJ and Todd will likely spend an afternoon (or two) just working through bugs to get the light modulation working strongly. Again, hoping no huge issues as this is a large part of the project.