What did you personally accomplish this week on the project? Give files or photos that demonstrate your progress. Prove to the reader that you put sufficient effort into the project over the course of the week (12+ hours).
I finished debugging our PCB, there were a couple of issues, mostly during development I didn’t comb through our MCU’s documentation’s well enough. So in summation I put SPI connection on pin 15 which is used to communicate to memory in the GNR8, another issue I created was putting signals on the usb differential pins, I thought that the differential pins were used for controller peripherals with them, not to literally control the MCU. Another issue is that I spatially created an invalid design, the IMU cannot sit where it should if there is a physical buzzer in the way. I have soldered and prepared the pcb for the interim demo.
Is your progress on schedule or behind? If you are behind, what actions will be taken to catch up to the project schedule?
Because i have a solution for the hardware, it doesn’t put the whole team behind, but it does put me behind. This pcb will be our screen and IMU testing board, so it does serve some purpose.
What deliverables do you hope to complete in the next week?
I hope to finish the updated design for the pcb and get started with integrating all the code from firmware and software.