This week I assembled the PCBs for the TX/RX boards and the TP Sensor. There was an issue with the TP Sensor where the pinout of the 3.3V regulator was not correct in the footprint of the design, so I ended up needing to use jumper wires to connect the regulator correctly.
After this, the board does correctly supply both 5V and 3.3V. I also was able to get a simple demo of the flush valve working, with the board being able to blink different LEDs based on different information sent over the NRF24L01.
We continue to be on schedule.
Next week is the demo so we will work on prepping for that, as well as polishing the system for the final public demo.
0 Comments