Theia

The start of this week was spent preparing the design review report, which was due on Monday.  Since the design review presentation we have redesigned the sensor orientation on our wearable.  To avoid complications regarding interference with multiple ultrasonic sensors, we decided to instead spend our budget on additional LIDAR sensors. We had been using the ultrasonic sensors because of their wider field of view, but if we get three LIDAR sensors and orient them all at slightly different angles…

Read More Read More

DESIGN DOC DUE EARLY THIS WEEK The beginning of the week was focused on creating and proofing our design doc. I focused on writing up the System Design section and Wearable Design. I also worked on the Bill of materials and our updates Block Diagram (As seen below). I also design a draft of the mount that could accommodate 3 LiDar sensors at precise angles relative to each other (depicted below). The plan is to design this in Inventor-Pro and 3D print the…

Read More Read More

This week I did a lot of work on the object recognition part, to really explore the capabilities of OpenCV and finalize our design for this part of the project. As a group we also spent a lot of time doing the design report. I decided that the best way to do fast object recognition for this project is based on the geometrical differences between the 3 different types of objects. In experimenting with online images, I found that edge…

Read More Read More

This week has consisted of a lot of group work, finalizing our design requirements and specifications.  Since I was giving the design review presentation, the front half of the week was spent heavily putting that presentation together and preparing to give that during class on Wednesday. Since then, it’s been a lot of group work as we finally have all of our sensors so we can really start collecting data and figuring out how we want our final design to…

Read More Read More

This week was mostly spent on finalizing our requirements and design for the project for the upcoming report. As a group we worked on setting up our various sensors with the raspberry pi and testing them out. Based on testing results and the distance and angle specifications for the ultrasonic and lidar sensors, I came up with a new design and worked out all of the math for a new sensor approach with 3 Lidar sensors, that we’ve decided to…

Read More Read More

This week our main focus was on the Design presentation and document. We worked on compiling our work. And finalizing our sensor configuration. We got the ultrasonic sensor to work with pi through an arduino and tested it as a team. We performed tests at 2m, 4m, 6m, and 8m (at varying degrees) in the lab room and tested varying modes of the sensor. We determined that the voltage mode was most acurate but the values were very unstable at 8m….

Read More Read More