Posted on

David’s status report 4/13/25

What did you personally accomplish this week on the project? Give files or photos that demonstrate your progress. Prove to the reader that you put sufficient effort into the project over the course of the week (12+ hours).

This week, I was still focused on integrating all 6 motors. I spent a lot of time reorganizing the wires, since our setup during the progress demonstration day was an absolute mess. This involved moving 3 of the motors to a third breadboard and shortening the wires so that they don’t get tangled up. We ended up having 3 breadboards where each contained 2 motor drivers. Then I tried to isolate the motor drivers one by one and debug them. This means using the same working combination of RPi GPIO pin and motor on each of the motor drivers to see which ones were faulty. We had to replace a few bad motor drivers but ultimately still haven’t achieved full integration of the 6 motors.

Is your progress on schedule or behind? If you are behind, what actions will be taken to catch up to the project schedule? 

I would say my progress is behind schedule since the motors are the most important part of our team project MVP and I still haven’t been able to fully integrate them with the rest of the system due to issues above.

What deliverables do you hope to complete in the next week?

As a team, we ran into setbacks with bad breadboards (such as rails that may have been burnt out) and really faulty motor drivers, so I plan to work together with Ashira in debugging the motor drivers one by one and finishing the integration of the motors.

 

Posted on

Anna’s Status Report for 4/12/25

This week, I focused on setting up and testing the passive infrared sensor. I explored multiple approaches to verify its accuracy, but unfortunately, I haven’t fully resolved the issue yet. Initially, I connected the sensor directly to the GPIO pins and printed “detection” based on the PIR’s state. However, this approach produced frequent false positives. In response, I researched alternative methods—experimenting with both the gpiozero and RPi.GPIO libraries, changing conditionals, sensitivity and timeout parameters, and even incorporating a LED diode that lights up upon detection. Despite these efforts, the false positives persisted regardless of how much I changed it. I suspect the issue may be related to the sensor’s sensitivity and timing, which I plan to debug further.

Outside of the PIR, I successfully helped Ashira get the speakers to produce sound by adjusting the wiring—this involved some frustrating debugging, but we eventually resolved it. I also assisted David with the motors by suggesting that lowering the Vref on the motor drivers could help achieve the expected rotation, which thankfully worked. Additionally, I reorganized the motor circuitry, consolidating it from 3 breadboards to 1 with Ashira.

Although I’m currently a bit behind schedule due to the PIR sensor not being integrated yet, I plan to go into the lab tomorrow to continue debugging. Hopefully, by next week, motion detection will be more reliable and we can move forward with integration.