This week, I have finished most of the model for the product that will house the camera and the jetson device. Pictures are attached. Each face has a bit of a jigsaw pattern so that a preliminary assembly can be done for prototyping without actually using a permanent solution like hot glue or screws. I intend to use wood to laser cut the material, so once I learn to how access wood, I will do so. The jetson will fit in the bottom compartment (almost perfectly), and the camera mount will stick out of the top. There will be a small platform inside the box that will act as the mount for the camera mount to attach to, so once I pick up the camera mount on Monday, I can configure how that will look. The holes in the box back side are for ventilation. I’m not sure if that would even be a concern, but it’s good to make sure, in case we happen to close the top for whatever reason. Wires will run from the bottom opening (where the jetson would be inserted), and this consolidation will make the product usage much easier. I may design a quick way to keep the jetson in place during operation.
